Computer engraving machine fault reason analysis

by:Transon     2020-04-24
Computer engraving machine failure, we should learn to observe, what is the real judge failed. From the following four aspects to analyze computer engraving machine: ( A) Alarm fault distance alarm, says the machine has reached the limit in the process of running for the position, please click the following steps to check: 1, whether the design of graphic size is beyond the scope processing. 2, check the machine motor shaft and screw loose problem is, if it is, please tighten the screws. 3, the machine and the computer is properly grounded. 4, whether the current coordinate values beyond the soft limit value. ( 2) Distance alarm and disarm overtravel, all axes are automatically set in dynamic state, as long as hold the direction key manually, when machine left limit position ( From the distance point switch) Restore the connection at any time when the motions. Pay attention to the direction of the movement, when moving workbench must be far away from the limit position. Soft limit alarm to XYZ can be reset in the coordinate setting. ( 3) The alarm failure 1, repeat the machining accuracy is not enough, according to paragraph 2 of article first check. 2, the computer operation, the machine did not move, check whether the computer control card connected with the electrical box head is loose, if it is, tight, and tighten the screw. 3, the machine can't find the signal when back to the mechanical origin, according to article 2 inspection. The mechanical origin proximity switch failure. ( 4) 1 the output fault. Don't output, please check whether the computer and control box is connected well. 2. Open the carving whether manager set in the space is full, delete unused files in manager. 3. Signal connection is loose, carefully check whether each line connection. Computer engraving machine fault analysis, learn to suit the remedy to the case, to solve the problem.
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...