Co2 laser marking machine maintenance and repair methods

Co2 laser marking machine what are the common faults, how to repair? China laser laser equipment factory as a professional CO2 laser marking vendors would, for you to provide comprehensive and effective CO2 laser marking machine failure and repair methods. China laser equipment factory has a professional after-sales service personnel to provide you with 16 hours of online services, for you to solve the problem of laser maintenance etc. 100 sets of more than 200 after-sales service network, after-sales service 24-hour on-call, 24 hours door-to-door service, to ensure after-sales maintenance problems timely response.





as more and more people are using co2 laser marking machine, the co2 laser marking machine maintenance related knowledge desire is becoming more and more obvious, especially for new to co2 laser marking machine, one on the operation and maintenance problems, don't know what to do. Today, laser laser machine equipment factory in China based on past customers often consult after-sales service problems, make a brief introduction for you.

1, laser GuanLiang voltmeter has instructed the

(1) the light is not straight Chang Dao light fever (joints Common in light loosening, and laser tube didn't pack is) Inspection method: with optical correction. Ruled out measures: to replace or adjust the light section, correct the light path. Laser power (
2. Common in laser tube aging) Check: use a multimeter archives check voltage regulator, voltage with a high table to check the working voltage of laser tube. Processing: to replace aging laser tube, and exchanging the damaged components.

2, laser tube is not bright,

1) voltmeter with instructions found in open circuit on the power supply line, and foot switch or a manual switch contact undesirable. Inspection: the measured with a multimeter. Processing: repair or replacement.
(2) the voltmeter is no instructions ( Common fuse, or circuit open circuit)
check measured with a multimeter. Processing: replacing the fuse, or circuit is connected.
(3) the power indicator light is not bright, Common fuse, into the line contact undesirable, indicator light circuit adverse or indicator light is bad) Check: check the fuse, check the power supply into line, check the indicator light circuit. Processing: replacing the fuse, repair, wires and replace the lamp. (4) continuous burning fuse ( Common in machine with short circuit, and the machine has serious contamination) Check: check line step by step, many short circuit for high voltage section. Treatment: short circuit to remove dirt.
5) machine with common machine or electric arc discharge with dust, water or air humidity is too big and corrosive gases. Check: to observe the discharge point in the dark. Processing: remove dust, water content, such as changing work environment.
6 laser output instability in CO2 laser marking machine is poor contact, short-circuit point machine with mild intermittent. Check: check line step by step. Processing: replace wire, welding head again, clean processing.

the above content, carbon dioxide laser marking machine maintenance also includes laser tube, lenses and other core parts aging, damage and other problems which need to be timely replacement part, if the customer need to replace parts, at any time can call China laser equipment factory after-sales service special line, 0769 - 89839999 turn line 1) Advisory details, also customer search taobao ( China laser equipment factory energy mall) Consult customer service for details, we have professional technical engineers at any time for you to answer questions or on-site maintenance equipment.