CNC engraving machine of the common problems and solutions ( 2)

Connect: CNC engraving machine of the common problems and solutions ( 1)
12: related reasons of engraving machine carving not
1, the power supply for AC220V50Hz electric

2, whether 3, whether to open the switch
4, has used serial line connects the computer serial port and engraving machine, whether connection secure
5, software output port Settings are consistent with the actual connection
6, whether to send the correct data format for carving machine solution

1, plug in carving mechanical and electrical source, turn on the switch
2, press the start button, send file containing want engraving content of the legal
3, restart the computer and carving machine

13: open software, computer prompts & other; Open the card failed, please check the card & throughout; The prompt.
the solution:
1. Check the card driver have installed, or change my card by a PCI slot;
2。 The two root data connections to installation, check if there is any breakage phenomenon;
3。 The board has a problem, replace the board.
14: open software tip: three axis alarm, initialization error 4. Check the computer have two wires connected with the machine; Check control box connecting plate of the fuse is burned, change the fuse;
3。 To check whether the normal power supply 5 v12v power supply.
15: sculpture dislocation occurs, or the wrong size. Check the path of the carving software correctly or not; The clearance check screw and the screw securing the polished rod have loose; Check software parameters set correctly or not. Computers have virus
16: walking the X axis when a certain period of Z axis not carried knives, press the up going but going down. Check whether the Z axis motor run normally, the size of the power and drive current; Check whether the Z axis motor line have poor contact or discontinuity.
17: spindle motor forward or backward. Check the inverter parameter setting; Transducer to signal whether pick up the three lines to connect inverter motor any two root swaps. In the case of frequency converter connection intact, motor does not turn, it bad
18: hit a knife. The Z axis motor power is not enough, loose coupling; The Z axis drive current is too small, or the wrong line. Check whether the Z axis motor line plug
19: open the software, when the phone is switched on a shaft to shut down. Drive problem or computer output signal poor contact; Poor contact motor line. Check whether the software set in the parameter is right
20: limit phenomenon appeared in the process of carving. Check whether the carving path is range of sculpture; Soft limit parameter Settings in the software.
the 21st: machine no electricity when the phone is switched on. Check whether the start button line is connected and whether the button burn out; Check whether the ac contactor is short circuit or burn out. Check whether the fuse is burnt
22: button when motion axis to one direction only. Check that the light lotus root line is working correctly and whether line contact good; Check the motor wiring for virtual welding.
23: send software can't normal open, graven things appear deformity. To install the new system and software; Check the X, Y axis screw and screw loose; Carving knife has a problem.
engraving machine price information in the numerical control network.