After carving machine power should pay attention to what?

Engraving machine back when the power is not the point of origin to do? I think the problem you are worry. When we use engraving machine can run into the problem of power outage, once a power outage, and to continue to carve dislocation it may not be able to continue, the origin can't go back. The Max CNC engraving machine way just to tell you about. First explain, carving machine is only one machine origin, this point is not the point, when we are in the use of engraving machine the z axis, the x axis and y axis, both the mechanical origin, back after ok, is also not afraid, when the power is when we use the engraving machine, computer and carving machine suddenly loses power, or all fault what computer crashed, we couldn't continue engraving machine, at that time we took the xyz these three axis are back to the mechanical origin, and then click continue engraving is ok, of course can also be senior began to break the number back inside, if you don't know this tube doesn't work, then back up after the mechanical origin, back to the origin of workpiece, the point is that we are processing your processing the origin. In order to reduce the unnecessary loss, be sure to remember when working all the xyz axis machine back to the mechanical origin! If it feels every time that breakpoint themselves back into the mechanical origin is not convenient to knife general x axis servo machine not misplaced, unless feeding, 45 degrees to the z axis.