Woodworking engraving machine maintenance

Woodworking engraving machine quality again good, long time no maintenance and maintenance is also often fails, to really make the equipment in the processing of for a long time to make our peace of mind, not only requires the quality of our equipment, often also requires us to equipment maintenance and maintenance, jia bang CNC is summarized below the woodworking engraving machine maintenance and maintenance work what are: 1. Equipment must first check whether the line is in good condition, before starting the voltage is stable, check again after open the machine power supply, operating machinery blank lines for a period of time at the start of processing. 2. Woodworking engraving machine spindle has two kinds, one kind is air cooling spindle, one kind is water-cooled spindle, water-cooled spindle the normal work of the need to keep the water clean and the water pump, clear here remind a bit: water-cooled spindle motor don't appear water shortage phenomenon. In addition to the above maintenance work also note the water temperature, cooling water temperature too high can lead to significantly reduce cooling effect, will cause certain damage to the spindle, so the replacement of cooling water in time. Frosty winter will prepare anti-freezing measures to prevent pipe. 3. Regular cleaning the wood carving cooling ventilation system of mechanical and electrical box, check the fan is working correctly, regular cleaning the dust inside the electrical cabinet, and check whether the terminal screw loosening, ensuring safe and reliable circuit is used. 4. Timely cleaning the guide rail and the surrounding wood shavings, and in a timely manner to filling equipment of transmission system. 5. Clean up the dust on the sensor powder and oil in a timely manner. 6. , woodworking carving machining has been completed, the burin first off, let the spindle chuck relaxed. To do so is helpful to prolong the service life of the spindle chuck. Then we started to clean the countertops, usable brush cleaning; Note countertops usual best don't pile up sundry, lest platform deformation. Finally to move the head to the left or right position to park, to prevent the collision, and then cut off power supply. 7. If long time don't use wood engraving machine, it is better to do electricity empty line once a week, to prevent the machine be affected with damp be affected with damp, guarantee the equipment electrical components is stable and reliable performance. 8. Cabinet is best not to often open, generally have a dust in the air when carving, wood or metal powder, once they fall on the circuit board or electronic devices within the electric cabinet, easy to cause the insulation resistance between the components to drop, even cause the damage of components and circuit board. 9. Regularly check whether woodworking engraving machine parts screw loose. 10. Vacuum pump maintenance, the water circulation pump suction mouths are used to prevent dust from entering the metal screen, screen to keep clean and avoid congestion caused by the pump pumping speed decreased, when the water pump should be run weekly electricity when not in use for a few minutes, to prevent rust pump body length can't operate properly. Optimal vacuum pump should also loosen the butterfly nut, remove the paper filter with high pressure gas cleaning filter on a regular basis, find filter, stuffy or damage to the should be replaced in a timely manner, according to the length of time of use hi-pressure oil gun to preview each bearing.