Woodworking engraving machine

Wood processing machinery. It is divided into three control modes: first, all the calculation work is completed by computer control, and the computer is in working condition when the engraving machine is working, and other typesetting work cannot be carried out, waste products may be caused by misoperation of computers; The second is to adopt the control of single chip Microcomputer. Engraving machine can be typeset while working, but the computer cannot be turned off, which can reduce waste products caused by computer misoperation; The third is to use USB port to transmit data. The system has a memory capacity of more than 32 M. After saving the file, it can be completely separated from the computer, shut down the computer or perform other typesetting, which can greatly improve the work efficiency. Precautions for use: edit 1. After setting the engraving position, all X, Y and z axis workpiece coordinates must be classified as '0 '. 2. Adjust the engraving speed and the spindle motor speed to prevent the cutter from being broken due to too fast and too slow speed during engraving. 3. When automatic tool setting, pay attention to the tool setting block must be insulated from the aluminum table of the engraving machine. 4. When carving, if you are not sure about the first knife or are afraid of making mistakes, you can slow down the feeding speed and turn the speed back to normal when you feel the carving is normal; You can also simulate carving in the empty process to see if it is normal. 5, if you do not use woodworking engraving machine for a long time, should be regularly weekly refueling idling, preferably for each week, to ensure the flexibility of the transmission system. 6. The continuous operation time of woodworking engraving machine is required to be less than 10 hours/day; To ensure the cleanliness of the cooling water and the normal operation of the water pump, the water-cooled spindle motor must not be short of water. The cooling water should be replaced regularly to prevent the water temperature from being too high and the circulating water should be as much as possible. The large-capacity water tank can be replaced. 7, every time the woodworking engraving machine is used, attention should be paid to cleaning, and the dust on the platform and transmission system must be cleaned up; Regularly lubricate the X, Y and Z axes of the transmission system. 8, the operator is best to wear dust masks and protective glasses when operating the woodworking engraving machine, in order to avoid the dust generated during processing to invade the human body, causing discomfort. 9, woodworking engraving machine daily maintenance method to add a certain dust and dust removal device in the woodworking engraving machine, choose dust removal equipment to use.