Why your wood carving machine life is short, so it's you do wrong these!

Recently is always complaining to do some furniture factory boss, why you buy the wood carving machine use of life is short, don't is to purchase channel? Actually brand manufacturer is on the one hand, on the other hand is that you may have made the mistake, it is the place clean up does not reach the designated position, then with the small make up together and see it: wood engraving machine clear after the completion of the work should be carried out on the table in time, to guide on the side of the chip material also want to clear in time, prevent lag; Screw in the equipment is very important, he decided that the precision of the machine, so regular cleaning screw is also very important, can effectively prevent a foreign body on the screw attached; Dust is one of the largest factors affecting circuit board, the box must be cleaned regularly labor. Put oil on wood engraving machine maintenance process plays a very important role. After will guide and lead screw is clean, in the oil; Refueling cycle is commonly once every two weeks; After add oil remember slow walking around, assure to lubrication degree; Wood carving machine even if not for a long time, also want to periodically go empty. We all know that board type furniture production line equipment regular inspection and maintenance is needed to guarantee its excellent performance, we may often be ignored in the process of testing the new replacement parts. Before changing accessories, some don't do technical inspection, maintenance personnel for new accessories for after installed directly to the engineering machinery, it is unscientific. Currently on the market to sell the spare parts of uneven quality fire, some fake parts the sham as the genuine; There are some parts due to the stock time is too long, performance changes, if not tested, often cause failure after assembly. Open new oil cooler cover, found that the side cover sealing ring without compaction, lead to the oil and water mixture, reason is the quality of the oil cooler is not pass. 1 sets of ZL50 loader, diesel engine oil pressure is too low, analysis is oil filter clogging, replaced the new oil filter, commissioning oil pressure is still low. In front of the replacement of new parts, therefore, be sure to make the necessary check test, test including appearance and performance test, new accessories to ensure trouble-free, put an end to its cause unnecessary trouble. Although the regular inspection and replacement of board type furniture production line damaged parts can effectively reduce the probability of failure, but we also want to test the new replacement parts quality and compatibility, and in this way can we make mechanical equipment normal operation. Can we don't delay our process!