What is the scrap of woodworking engraving machine processing, how to set up the machining path - - 【 】 Engraving machine _ _ _ _ CNC engraving machine woodworking engraving machine carved

what is the scrap of woodworking engraving machine processing





scrap wood engraving machine is a kind of finishing machining process. When to rough machining tool used is bigger, will be left in the engraving area area is opposite bigger, more bits and pieces of scrap area ( Possible distribution in the area of has carved) , at this point, the refinement process will have to use the material processing, otherwise it will cause scrap in the processing area carved out and influence the effect of carving problems





in fact is a kind of regional of scrap processing, only the machining area is to coarse material left in the residual area, processing these areas also want to rely on a certain process control parameters, main parameters are: overlap rate, path interval, which tool lateral feeding, cutting tool lateral feeding methods and principles with the front to the definition of rough machining. Residual material filling processing cutting tool path of feeding way is ring cutting knife.





because of the diameter difference between the cutting tool is less than 2 times, general won't produce scrap, so scrap, used in high frequency mode of products are machined on the current carved in the plastic mold processing must use scrap processing technology.





how to set up the machining path





Beijing carved software JDPAINT surface below of scrap processing order it is good to select the default





what circumstance fill use of scrap processing better





fill surface residual material processing is based on layered area for rough machining. In the use of layered regional rough machining sculpture complex process, in order to improve the efficiency of engraving, we usually need to complete the coarse carved with large diameter cutter. But big diameter cutter will leave residues, in an internal Angle position and some narrow area big knife carving.





in addition, in hierarchical processing may be on a flat surface when leaving a large number of steps of residual material because of the hierarchical. Used in finish machining, the tool is generally small, at the time of the residues of cutting big some. Therefore, it is may wreck a knife for scrap is too large. At this point, you need to use surface residual material processing