Stone engraving machine cutting too disturbing to mesa? Manufacturer is to teach you how to solve

To use stone carving machine to process the perforations friends, often inadvertently mesa hell to easy to operating, this problem will be a lot of friends met! So how should we solve this problem? Please look at our manufacturer share tips for you! 1, located in the Z axis, not to let the knife material surface, but moved directly touching the mesa material let the knife, it is ok to meet, don't deep, Z axis XianGui zero in this place, and then according to the article you would set the cutting depth in improving the corresponding height, ( In the Thai Settings, such as your cutting depth is 10, so here we accurate make knife up 10, in the Z axis to zero again, this is the origin of the Z axis. According to the article would set the depth, the machine under the lowest point is the place where my family a zero, is at the top of the mesa that to ensure the material completely carve without carve to mesa. ） 2, would the cutting depth is set to 0, then high when save path, tool set distance can be. 3, micro switch may also be used to carry on the upper and lower limit, each axis 2 limit switch, do hardware limit psychology has a base hit mesa anyway. Or the use of correlation light tank, but if there is no chip, correlation is likely because of debris into and out of trouble. Master these three points, not afraid of stone carving machine again injured mesa, still in use, please friends more keen, any damage will affect the overall operation of production and processing!