Stone engraving machine carved wood?

Stone crafts etc on the market at present, more and more, and the material of this type of engraving machine can engraving is very much, is suitable for marble, granite, bluestone, jade, crystal, tombstone, agate, ceramics, glass, plastic, chemical synthesis such as board, bamboo, wood, surface material. Therefore, some engraving machine between carving material is interlinked. Stone engraving machine carved wood? Stone carving machine can some kinds of wood carving, it is because it is much more a sink, stone carving machine body bearing effect is good, the space height is higher than general engraving machine, and it and wood engraving machine processing principle is basically the same, just using the tool will be different, so it can be carved wood. Stone carving machine has a very wide range of application scope, so the equipment operation is likely to be more frequently, it will be very attention in the maintenance, the maintenance items are as follows: 1, stone carving machine after finished the work, must pay attention to clean up the table and exposed the dust on the electrical accessories and so on, including machine guide rail and slide block, including screw of the machine and spindle motor. Including industrial control box machine, especially in the industrial control box dust slightly more will lead to a circuit board run out of the question, it is easy to appear the breakpoint, run, and so on and so forth. Attention to regularly clean up some of guide rail material crumbs, this can prevent debris interference resulting in carving machine appears lag. 2, the case of the above dust also keep in mind that regular cleaning, this can ensures good heat resistance, and can effectively prevent industrial control card exception error. 3, stone carving machine when not in use, at room temperature under the condition of low best pour out the water from the water tank, prevent frost crack phenomenon. The effects of temperature on carving machine is not very big, but due to many clients to screw with butter, winter also forget to clean up, each boot operation does not open, some workshop temperature is very low, while the oil, can still frozen, the machine running. Stone carving machine equipment maintenance is a very important part of, to better use the operating machine, more attention should be paid to clean on a regular basis.