Stone carving machine use in fault analysis

Failure analysis of stone carving machine using engraving machine that breaks down the hard to avoid in the process of use, understand some common fault analysis solution is necessary, here introduces five kinds of common faults of the solution. Alarm fault distance alarm, says the machine has reached the limit in the process of running for the position, please click the following steps to check: 1, whether the design of graphic size exceeds the processing scope. 2, check the machine motor shaft and screw loose problem is, if it is, please tighten the screws. 3, the machine and the computer is properly grounded. 4, the current values are within the soft limit numerical range. Distance alarm and disarm overtravel, all axes are automatically set in dynamic state, as long as hold the direction key manually, when machine left limit position ( From the distance point switch) Restore the connection at any time when the motions; Pay attention to the direction of the movement, when moving workbench must be far away from the limit position; Soft limit alarm should be in the coordinates set XYZ can be reset the alarm failure 1, repeat the machining accuracy is not enough, according to paragraph 2 of article first check. 2, computer operation, the machine did not move, check whether the computer control card connected with the electrical box head is loose, if it is, tight, and tighten the screw. 3, the machine can't find the signal when back to the mechanical origin, according to article 2 inspection. The mechanical origin proximity switch failure. Output failure 1, no output, please check whether the computer and control box is connected well. 2, open the engraving manager whether set in the space is full, delete unused files in manager. 3, line connection is loose, carefully check whether each line connection. Engraving failure 1, whether the parts of the screws is loose. 2, check their processing path is correct. 3, whether the file is too big error is processed by the computer. 4, increase or decrease the spindle speed, so as to adapt to different materials, General is 8000 - 24000). 5, unscrew the knife holder, clamping transfer knife direction, put the knife is, lest sculpture objects is bright and clean. 6, check the cutting tool damage, change new knives, carving.