Some taboos in the process of installing engraving machine

by:Transon     2020-04-10
There are a lot of users think that the installation of engraving machine method is very simple, so in the installation of the time does not pay attention to the correct installation method. In fact, although the installation method of engraving machine is very simple, there are many small details to pay attention to in the installation process, especially some taboos that cannot be touched. The specific contents are as follows: first, woodworking engraving machine stereo engraving machine installation instructions 1. Do not install this equipment during lightning or Thunder, do not install power outlets in wet places, and do not touch uninsulated power lines 2. Computer operators must undergo strict training and must pay attention to personal safety and machine safety during operation, and operate computer engraving machines in strict accordance with operating procedures. The power supply voltage requirement of 220 or 380 depends on the model. If the power supply voltage is unstable or there are high-power electrical equipment around, please be sure to select the stabilized power supply 4 under the guidance of professional and technical personnel. The engraving machine and the control cabinet must be grounded, and the data cable should not be plugged in electrically. Operators should not wear gloves to work, it is best to wear eye protection 6. The mechanical body is a steel structure gantry part of aviation aluminum castings, relatively soft, when installing screws (Especially when installing the engraving motor)Don't push too hard to prevent slipping. 7. The cutter must be installed and clamped to keep the cutter sharp. The blunt cutter will reduce the engraving quality and overload the motor. 8. Do not put your fingers into the working range of the cutter, and do not remove the carving head for another use. Do not process materials containing stone white cotton. 9. Do not exceed the scope of mechanical processing. Cut off the power supply when not working for a long time. When the machine moves, it must be guided by professionals. 10. If the machine is abnormal, please refer to the operation manual for troubleshooting or contact the dealer for resolution; So as not to cause man-made damage. Second, stereo engraving machine- Inspection items of woodworking engraving machine 1. Whether the screws in various parts are loose. 2. Check whether the path handled by yourself is correct. 3. Whether the file is too large, tens of millions of computer processing errors. 4. Increase or decrease the spindle speed to adapt to different materials (Generally 8000-24000) 5. Loosen the knife Chuck, clamp the knife in the direction of rotation, and put the knife in the right direction, so as not to make the carved object not bright and clean. 6. Check whether the cutter is damaged, replace it with a new one and re-carve it. I hope that when you install the engraving machine, you will mainly have these problems, so you don't have to worry about the normal operation when you use it.
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...
88888888888888888888888