Small cutting machine mould using rules

If under the condition of the plate in the down position on the start, just beginning to start into the mold piece, then for the rotational speed of the small cutting machine is not up inertia small, incidental and cars. Whether manual or electric compressor, the compressor should make up in the core rod before initiating the upward position and then start again. Electric pressure for a little while to roll on the handwheel handle down, lest hurt during operation. Small cutting machine operation (only in a certain direction See the arrow on the handwheel or shield) , be counterclocked, so as not to damage parts. Belt dancer: by mechanical and electrical floor two adjusted by the adjusting nut. Should be controlled before first use things carefully read the package insert to the machine, then use. , no power supply on hand presser, v-belt should be removed, in order to reduce resistance and wear. In pressure were especially need to pay attention to, don't neglect. But don't put the big pulley is removed, due to the large pulley have a function of the flywheel energy. After adjusted the attention to lock.







dongguan, dongguan laser spot welding machine, laser cutting machine in dongguan