Optical fiber laser cutting machine is the key to the light solution

At this moment we should pay attention to pay attention to the water inlet and outlet water conservation, not opposite, or it will damage the laser tube. If the power table pointer indicates a normal, check whether the laser tube is a light, if the pipe is light, but not to come out is the optical fiber laser cutting machine laser light pipe damage.
general, everyone looked in optical fiber laser cutting machine is the key to the light reason, usually there are three reasons, the following, we are the big fellow laser cutting machine is to simple introduce for everybody. If is still not out of light, laser power supply is broken, looking for a manufacturer to change. Begin to use everything is normal, the next day after not again turned on a light, monitor the water cycle of the laser cutting machine, laser cutting machine is normal. B, check the laser cutting machine of the ammeter is normal, if the normal is likely to be the subject of the laser tube, looking for a manufacturer to replace or repair, if the current meter is not normal is the topic of laser power supply, looking for a manufacturer to replace or repair. Check method is to take tape to stick on the first mirror some out of the light, see if there are burned by the light on the tape, if do not have that laser tube not, find a replacement laser cutting machine manufacturer.
。 The second way is to short for the PG on the laser power supply, With a line connecting) But at this time to pay more attention to check the water cycle, water conservation, avoid the laser tube is still can damage. If laser tube outer without water, then let us examine the laser power, laser power supply has a red button, click and see whether there is a light, if light, description may be water protection device fault, we feast customers check to protect water outlet is blocked, and then clean water conservation, match good wash with water. B, check the ammeter laser cutting machine, and press the 'light' laser cutting machine to see if the ammeter pointer played up, if be below 5 ma, that is the power supply is broken, looking for a manufacturer to replace or repair. C, if the current meter, check out our laser switch to have open, if open again to see if the laser power light bright, bright, press the off button on the laser power supply, hand look at current, such as Pointers and less than 5 ma, laser power supply is broken, or in the software to match the light intensity and color exaggerated to 50%, according to whether the ammeter pointer to 10 - again 12 ma, if do not have to is the topic of laser power supply or the mainboard. About out light reason check the water cycle flow situation of laser machine, nozzle tube is out of the water, if the customer said in the morning, or more than two hours, then feast customer first to check the proportion of carbon dioxide laser tube outer whether there is water, if there is water, it is due to high temperature laser tube destroyed. , about the use of laser tube in the process of light more and more weak reason check laser machine water cycle, laser cutting machine if water is not rebirth please check after off pump or cold water machine plug is good.






pneumatic cutter adopt what kind of cutting tool is more