Introduction to the solution to errors in the operation of stone engraving machine

by:Transon     2020-04-09
If you find a dislocation in the process of operating the stone engraving machine, don't worry too much. At this time, you can take some measures to avoid the impact on the engraving work. So how should it be operated? Next, let's take a look at some methods and techniques to solve this problem. How should users of stone engraving machines be misplaced during the working process of engraving machines be handled? Dislocation of stone engraving machine involves many problems of engraving machine itself, so it has always been a difficult problem to solve. We have told you some methods to prevent dislocation through years of experience in operating engraving machine. First of all: the reasons for the drive will cause dislocation. If the dislocation phenomenon does not appear much in the carving process, the carving speed can be slowed down appropriately. If the dislocation occurs at the beginning of the carving, the driver may be broken, and the driver should be repaired or replaced as much as possible. The second point: if there is a problem with the interface board or the main board adapter board, the machine will not move all three axes when carving, which will also cause dislocation. The third point: the voltage is unstable. If the voltage is too low, it will not reach the power required by the engraving machine, and it will also cause dislocation. This situation is mostly found on the y-axis engraving machine, therefore, it is best to install a 50000 watt regulated power supply before using the engraving machine. The fourth point: there is a fracture of the engraving machine tool line. Finally, there are problems with engraving machine components, such as poor fastening, or impurities on the surface, which may lead to dislocation. These are several aspects that should be paid attention to in the process of using stone engraving machine. I don't know if you still have any questions about this aspect after reading it?
Custom message
Contact