If the error of the cutting machine appeared what can adjust?

Cutting machine a error on how to reset? Cutting machine manufacturers, remind everybody to work in the use of cutting machine, cutting machine may present some use error, check out of the subject, first check the die cutting machine use have worn or damaged phenomenon, if is this kind of phenomenon caused by the error, you can change a mold. This time, adjust the workings of a cutter to the state of 'dynamic adjustment', and then remove the mould of machine tools, or some other accessories, so that we can make the slider stays on the mechanical stop, and then the pressure gauge to the need of pressure value. The dial indicator 3 - header compression 4 mm, stepping foot let system booster, booster in cutting machine system or the system charge, check the dial indicator clock offset, if to delimit the value, we can rest manipulation, this time you will find that the error of the questions have been resolved. If Angle cutting machine parts there are still some error, it may not be due to the mold, or is the topic of parallelism, it may be a laser machine system, the balancing mechanism around there is no guarantee that the average pressure oil into the cylinder, it needs to adjust. In the process of checking if there is no development of the phenomenon of damage, just check the parallelism of slide blocks and workbench, if the demand cannot be satisfied, can according to the regulation of machine tool slide block and the workbench parallelism, 'the book of knowledge, to adjust.