Engraving machine limit alarm?

Recently, many customers consulting small make up, when operating engraving machine engraving machine appear beyond the situation of stroke or limit alarm suddenly, this kind of situation should be how to do? This function can be smart protection of the machine working mesa, prevent the path distance or operating errors may cause damage of the mesa. Intelligent processing cross-border protection to prevent the design layout more than processing mechanical collision phenomenon caused by the wide. So, carving machine limit switch to trigger later how to remove? Each carving machine has its own work schedule, said some popular is the work area of the machine. Only within this range to engraving, the machine can run normally. Once beyond the maximum size of stroke machine, control system will prompt: limit the trigger. Limit switch alarm after the machine will automatically stop running. When we met there is a limit alarm of engraving machine we only need to release the alarm. Carving factory under the home here teach you how to limit the release of engraving machine operation? Actually very simple, just click the operation under the menu 'limit the release of' machine moving in the opposite direction can be lifted. This feature is temporarily blocked limit function, use the manual operation is back to normal position of a machine tool. Because this time limit effect has been to block, so the operator cannot be too careful when using this function. Another is carving machine travel is not to the limit, please click on the I/O status, check which axis alarm, then unplug the photoelectric switch, if not warning that photoelectric switch failure, or reverse polarity.