Engraving machine, how can achieve precise carving

1) Set the specific method is: according to the range of different types of stone engraving machine, with the method of manual movement of machine tool, the machine movement to the limit of three axis location respectively, until you hit the trip switch, record the X, y, Z of three axis movement to the minimum and maximum coordinate values,
input parameters in the corresponding position. 2) For the knife. This parameter is used to set you use the knife knife, the knife instrument center of X, y and Z axis rapid decline in the distance, The Z axis) 。 'Processing time' can make the operator before the sculpture carved the time to know in advance. Its calculation is based on a set of carving parameter, the time required for processing the current file carving, this time does not include the middle of the tool change, positioning, such as time, is a estimate value. 'Processing time' carved parameters including the cutting speed, feed rate, the cutting delay, Z axis stroke, etc. , also related to the mode of 'priority'. Switch path attribute set properties 'path switch' is mainly used to control whether or not to use in the manufacturing process of the parameters for processing path. These parameters include 'feed rate' and 'spindle speed' 'slow down, distance' 'rapid tool height' and 'down, delay time'. Switch Settings 'commands' path in 'extensions', can press key combination 'Alt ~ - G 'and then press' K 'key to call, the system will pop up' switch path attribute 'dialog box, the system default 5 options for the disabled state, to open one or more options, just use the mouse to click on the front small box of the make it have a tick marks, also can through the' Tab 'key to move the cursor, then press the' Space & # 39; 'key, will need options open. For high level programming or mature technology, can be set at the time of cutting tool path programming good sculpture processing parameters, processing to open 'path attribute switch ', according to the path with parameters for processing, but when the trial cut and started processing, should be closed' feed rate 'switch, setting a lower into 3) Change the tool. This parameter is used to set the convenient tool change 'change tool' three axis X, y, Z coordinates. Set up after the 'dao', the use of 'special movement' in the
'to change the tool', to set the location of the movement to the nose, waiting for the operator to change operation. Engraving machine software detailed setting method is: the manual control of the position of the machine tool movement to make the operation tool change, record the current machine tool coordinate values of the input to the corresponding position 'parameters'.