Engraving machine drive bright red light is what reason, how to deal with - - 【 】 Engraving machine _ _ _ _ CNC woodworking engraving machine engraving machine carving factory house

drive bright red is the reason why





1, the judgment is drives appeared problem, drive is broken;


2, and eliminate the problem of not driver don't pick up the motor is A green light, is the problem of the machine


3, attachment problems


4, drive current and the inappropriate


5, the load is too big,





how to solve the engraving machine drives red light





1, advising clients to inspect or replace the drive


2, and eliminate the problem of not driver don't pick up the motor is the green light, is the problem of the machine, change the motor


3, line down the drive motor, disconnect the motor on the other side of the line again, measured with A multimeter, A + and A - should be normal Channel B + and B - Is the pathway. Group A and group B line should not be interlinked, but found A measurement line there is A group A and group B line, which is 4 lines in the three of them are interlinked, so judgment is A connection problem, replace wired,


4, check whether push that has axial mechanical parts has A problem, clean the screw and light, and if you have any questions, you can make the drivers and other shaft drive change, drive in other changing drive shaft also appear on A red light, if the other drives A red light on this axis will be looking for A mechanical part of the problem.