Engraving machine carved solution can not be at the origin

by:Transon     2020-04-23
1, speed skate solution (1) not installed ground, electrostatic, which results in the speed skate, dislocation (2) the software printer parameters do not tally with the engraving machine printing parameters often 2, sculpture, hard material cutting knife solution (1) is required for a hard material carving set different engraving parameters according to different materials, to use a different tool (2) select the appropriate lubricant 3, carving machine start reset beep or always good top limit switch bad solution (1) the top peak of less than limit switch, its calibration. (2) drive line contact is not good, try to fix the drive line it tightly. (3) limit switch line not connected, the line can be connected. (4) limit switch bad, in the can. 4, carving machine cannot be at the origin carving solution (1) whether file size with the machine match; (2) check whether has offset ( 抵消) , layout Settings are correct. 5, engraving machine working process of the spindle motor sudden halt or slow solution (1) working voltage instability or super load, add a voltage stabilizer; (2) check whether the median line connected and the thread if there were any desoldering. 6, carving machine set forward, sometimes to the right when the origin offset distance variable solution (1) limit switch failure, in the process of the system back to the origin of the limit switch closure and bounce off first. Change the limit switch. (2) drive line loose, managed to keep its fixed.
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...
88888888888888888888888