Engraving faults often encountered in engraving machine work

I believe that everyone will encounter some problems when carving. In fact, there is a very simple solution to this problem. As long as the fault of carving is found, the problem can be solved, sometimes not the problem of the machine. When looking for faults, you should be good at finding them so that the problems can be solved. Let's take a look at the faults encountered in carving with me! Friends who are interested must not miss it! First, check the screws, sometimes it is not a problem with the machine, but a failure caused by the parts of the machine not being installed. Before the machine runs, check the screws to see if they are loose. Sometimes, things that seem very small can lead to very serious consequences, just like the importance of the barrel effect. Second, check the path machine can not operate normally, may be because the path does not correspond to lead to a series of failures, very difficult. At this time, we should start from the most basic search, sometimes because the file is too large, resulting in computer calculation errors. This will lead to carving failure and affect the operation of the work. Three, check the blade, sometimes because of the wear of the machine parts, or rust and other phenomena. This will lead to the carving failure, there will be some problems in the carving, the work can not be normal operation. If such problems occur, they should be updated in time and replaced with new blades or materials. When carving, the failure should start with the most basic so as to find the problem and solve it fundamentally. I hope that when you are working, you can eliminate the fault and make the normal operation of the work to carve a satisfactory work.