Easily solve the stone carving machine common faults

stone carving machine that breaks down the hard to avoid in the process of use, understand some common fault analysis solution is very important, we listed some some common problems in the process of stone carving machine use, hope to help build customer. A, alarm, fault

distance alarm, said the machine in the running process has reached the end of the position, please click the following steps gradually check:
, whether the design of graphic size exceeds the processing scope.
and check the machine motor shaft and screw loose problem is, if it is, please tighten the screws.
, machine and the computer is properly grounded.
, the current values are within the soft limit numerical range.
2, overtravel alarm and disarm
distance, all axes are automatically set in dynamic state, as long as hold the direction key manually, when machine left side position ( From the distance point switch) Restore the connection at any time when the motions; Pay attention to the direction of the mobile when moving workbench, the need to stay away from the end position; Soft limit alarm to XYZ can be reset in the coordinates set
3, the alarm failure
, repeat the machining accuracy is not enough, paragraph 2 of article according to the inspection.
, computer operation, the machine did not move, check whether the computer control card connected with the electrical box head is loose, if it is, tight, and tighten the screw.
, the machine can't find the signal when back to the mechanical origin, according to the first article inspection. The mechanical origin proximity switch failure. Fault

4, output, the output, please check whether the computer and control box is connected well.
set in space, open the engraving manager whether is full, delete unused files in manager.
and signal wiring is loose, carefully check whether each line connection. Fault

5, sculpture, whether all parts of the screws is loose.
and check their processing path is correct.
computer handling errors, whether the file is too big.
, increase or decrease the spindle speed, so as to adapt to different materials, As a general rule, be - ) Unscrew the knife holder,
and clamping transfer knife direction, put the knife is, lest sculpture objects is bright and clean.
and check whether tool damage, change new knives, carving.

if it is just to buy the machine have problems, please consult a businessman, not careless operation or Settings, in order to avoid hard damage on the machine.