Jinan Transon CNC Equipment Co., Ltd.
S I N C E 2 0 1 0
Latest products
Cutting machine safety operation procedures
by：Transon
2020-10-30
Is not allowed when bending and workers gauge between the upper and lower die debris piled up.
choose accurate bending mold, upper and lower die fastening position accuracy, installing a upper and lower die control to prevent injury. Accurate choice bending stress, partial load pressure should be less than 1/2 of pressure.
before bending after checking equipment without exception, idle running before being manipulated.
abnormity cutting machine immediately block the power supply, resting and inform the relevant staff in time troubleshooting. Large bending parts, to prevent the sheet up face cuts.
cutting machine lubrication part should be to cheer on schedule.
students must grasp the accurate way of using the related equipment and tools, bending machine can be manipulated. 。
when people manipulate, make sure the main manipulator, and by the main manipulator control the use of the pedal switch, other employees may not be used. Large bending stress bending length parts shall not be less than 1/3 of the length of the workbench. Installing a bending die driving is prohibited.
students into practice, Practice) Site will obey teachers arrangement, wear good clothes, tighten cuffs, wear a good working cap; Seriously listen to, watch carefully, do not play play, keep the venue clean and tidy.
when completed, the detection power, cleaning the work place.
pneumatic cutter material supplies
choose accurate bending mold, upper and lower die fastening position accuracy, installing a upper and lower die control to prevent injury. Accurate choice bending stress, partial load pressure should be less than 1/2 of pressure.
before bending after checking equipment without exception, idle running before being manipulated.
abnormity cutting machine immediately block the power supply, resting and inform the relevant staff in time troubleshooting. Large bending parts, to prevent the sheet up face cuts.
cutting machine lubrication part should be to cheer on schedule.
students must grasp the accurate way of using the related equipment and tools, bending machine can be manipulated. 。
when people manipulate, make sure the main manipulator, and by the main manipulator control the use of the pedal switch, other employees may not be used. Large bending stress bending length parts shall not be less than 1/3 of the length of the workbench. Installing a bending die driving is prohibited.
students into practice, Practice) Site will obey teachers arrangement, wear good clothes, tighten cuffs, wear a good working cap; Seriously listen to, watch carefully, do not play play, keep the venue clean and tidy.
when completed, the detection power, cleaning the work place.
pneumatic cutter material supplies
Custom message
