Cutting machine mould specification

To ban the use of cutting machine mould fold over thick iron or steel, high alloy steel, square steel quenching far more than sheet metal and sheet metal cutting machine function, so as not to damage the machine. Sheet metal bending when necessary compaction, prevent the sheet metal cock damage control staff when bending. Always check upper and lower die contact ratio; Pressure gauge indicates whether conforms to the defined. Cutting machine at the bottom of the upper die downward when necessary to ensure there is a thickness of the gap.
。 Otherwise, can cause damage to the mold and machine. Seal cutting machine, want to be in on both sides of the cylinder at the bottom of the lower die on placing block will slide down to block. Stroke is the regulation of electric adjustment and manual fine tuning. Stroke adjustment, mould in the official start of the cutting machine for bending work need trial run. Say die under the change of variable cutting machine, bending machine do not allow to have any contact with the lower die. Such as bending sheet of 4 mm, need to choose around 32 slot. To exit the program control system, after the detection power. Check the cutter contact ratio of upper and lower mold and robustness; Check whether the positioning device meets the requirement of processed.
cutter mold how specification to use, have the following: through the power of the cutting machine, turn the key switch, press the oil pump start-up, cutting machine oil pump start rolling, the machine has yet to begin to work. The sheet metal die block should be used when the power supply, resting after the operation. Slit choice, cutter mold bending machine generally choose thickness of 8 times the width of the slot.









laser cutting machine laser oil should begin from the following options