Cutting machine is not the cause of the pressure

Then we from oil to find this see if laser 3 d system valve core are stuck, or hydraulic control one-way valve core is card, or the spring inside the elastic is not enough, to the normal pressure hydraulic controlled check valve cannot lock oil, oil or fuel tank laser is less, then according to the oil pump is normal movement, we look at the machine open valve group and the oil return hole is below normal oil return, is to screen. Cutting machine using efficient, but in the process of normal use, if do not pay attention to maintenance and control requirements, will cause the damage to the equipment, the equipment in normal use process, for example, may not on the pressure, if the equipment can't afford to build pressure, how do we find out about topics? The following article, for everyone. 。 We, of course, is from the cutter machine oil to the two aspects of circuit and the first screening, cutting machine circuit first aspect is relatively easy screening, we see first stepped on the foot switch, electrical cabinet inside under the control of contactor will work in absorption, first determine the contactor is normal, if the normal, and look at under the control of electromagnetic valve of the light is on, if light, electromagnetic light valve on the side of the valve core is can normal movement both inside and outside, and then see if the time to continue in the electrical appliances failure, these a few respects to undergo screening. Cutting machine in the operation of the equipment, royalty - encounter without pressure, the errors in the department of a big reason is that manipulation, if is the cause of human, and not in a timely manner to improve, can cause equipment loss serious, so should pay attention to screen in the use of the equipment and maintenance, to make the equipment running effect is good, reduce unnecessary losses.









pendulum cutting machine price analysis punch stamping noise problems and sources