Common problems in the process of carving machine use solution - - 【 】 Engraving machine _ _ _ _ CNC woodworking engraving machine engraving machine carving factory house

Common problems in the process of carving machine use solution





engraving machine equipment figure

CNC machinery co. , LTD. , integrating research, development, manufacture all kinds of woodworking advertising engraving machine | jade stone carving machine | | metal mold engraving machine series of optical fiber laser five-axis robot | | styrofoam CNC mortise and tenon joint processing center production line | | customize household and other several
control engraving machine series, welcome to inquire!
one, and how to solve things appear deformity or send program cannot normal read
( 1) Carving path if there were any problems
( 2) To install the new system and software;
( 3) Check the X, Y axis screw and screw loose;





2, how to solve the machine no electricity when the phone is switched on.

( 1) Check whether the ac contactor is burned or short circuit (
2) Check whether the start button line burn out or pick up good





3, how to solve the hit a knife.

( 1) Loose coupling, Z axis motor power is not enough
( 2) Check whether the Z axis drive signal lines wrong or too little electricity
( 3) Cable didn't answer.





4, how to solve the wrong size and dislocation in the time of carving.

( 1) Check the carving software program road is correct
( 2) Did check the polished rod fastening screw loosening and screw clearance size
( 3) Check programming parameter Settings are correct





five, how to solve the transfer program, open computer prompts failure, please check the card.

( 1) With data connections to installation, check if there is any breakage phenomenon
( 2) Check whether the board's driver has a problem, or put the card in a slot (
3) Change d macro card





6, how to solve the axial operation Z axis don't lift sword

( 1) Check whether distance tool set up
( 2) Check whether the Z axis motor line have poor contact or discontinuity in the

7, how to solve the switch on the machine, the prompt shaft closed
( 1) Poor contact motor line.
( 2) Computer output signal poor contact or drive

eight tip: when and how to solve the open software initialization error signal, triaxial alarm
( 1) Check whether the power supply is normal power supply
( 2) Check the machine and computer are the two wires connected
( 3) Check whether control in connecting plate of the fuse damaged

9, how to solve the spindle motor does not turn or reverse
( 1) Pick the transducer signal whether.
( 2) Check the frequency converter set the parameters of the

10, how to solve the axial motion axis to one direction only.
( 1) Check the motor wiring for virtual welding.
( 2) Check whether the data line socket is inserted or cable for damage