Common fault diagnosis methods (laser cutting machine 9)

Firstly, dimmer road 1, laser power transferred to around ten percent, and then turn off the laser on, and then to dimmer. 2, the first light of the adjustment with transparent adhesive tape on the reflective body some first, confirm whether the light in the middle of the mirror, and then adjusted by the adjustment screw three rotation on the mirror, light in the center of the lens barrel, put laser mouth to go up and then some, whether in the center of the laser's mouth. 1, correction laser vertical laser power first transferred to around forty percent, with organic plate to confirm whether the upper and lower two light vertical, if after vertical light. 2, if on the organic board, light Angle adjustable laser tube before and after high and low, inclined adjustable laser tube bracket swinging around. 3, light: the laser focal length for confirmation from top to bottom, first on the right of the laser head and the front of the screw loose. 4, with iron plate field type, cutting seam width adjusting the knife, vertical degree of iron plate.