Air laser cutting of economy, efficiency and applicability

Air laser cutting of economy, efficiency and applicability. Laser cutting machine at the time of processing, must want to use the protective gas, air, of course, is simple and economic protective gas, and the effect of air compressor is part of the compressed air with high purity oxygen and high purity nitrogen gas cutting gas for cutting head, the part as power source supplied to cylinder clamping workbench, after blowing dust removing part of the system is used to light the road, from the air out of the compressed air after gas-holder and dryer after entering pneumatic tank, then through a set of sophisticated processing system, into a clean, dry gas, eventually into three road, respectively as cutting gas, cylinder dynamic positive pressure air supply and light road dust gas to maintain the normal operation of the laser cutting machine, so the air compressor is an essential part of each laser cutting equipment, is also very important for laser cutting machine. Provided directly by the air compressor and air, so compared with other gas prices also seem to be very cheap. Although containing about 20% of the oxygen in the air, but the cutting efficiency is much less oxygen, cutting ability similar to nitrogen. Cut surface will appear trace oxide film, but can be used as measures to prevent a coating layer falls off. Incision face yellow. Its main material is aluminum, aluminum alloy, stainless copper, brass, galvanized steel, nonmetal and so on.