After aging woodworking cutting machine often have what problem?

Early furniture industry use push Taiwan saw not only time-consuming, laborious to artificial requirement also particularly high, most of the furniture enterprise are all very bad headache is artificial control, with the progress of era most furniture companies are now using the multiplying of woodworking CNC cutting machine improves the efficiency, but with the passage of time equipment also in the process of the wear and tear of aging slowly in occasionally appear some problems, such as machine abnormal then small make up of judah explain for everybody will meet the common abnormal problem.

a: precision variation
1, the first to know of the drive for woodworking CNC cutting machine, rack drive or screw drive woodworking CNC cutting machine, rack drive is not easy to wear usually buy equipment after a period need to adjust the parameters of pulse.
2, screw drive is usually in 1 - 2 years precision, mainly depends on the quality of screw, screw transmission of woodworking CNC cutting machine precision if accuracy deviation smaller can adjust the parameters of variation but if there are too much accuracy deviation will need to replace the screw.

2: spindle's unusual
1, overheating, first check whether the water pump is working, the water cycle system is under the reason such as the water cycle is too small will cause main axle overheating;

2, spindle motor didn't force to see if there are any more but phase line check the motor cable, cable short circuit, voltage instability or no force can cause the spindle motor is fixed the phenomenon such as;

3: spindle motor noise anomaly
1, check to see if the motor overload, need to adjust the feeding speed and turning, adjustment after still have intention probably spindle motor fault phenomenon shall promptly repair or replacement.